NewsMilvian AI Strengthens North American Sales Leadership with Appointments of Todd Brinegar as Chief Revenue Officer and Patrick Pinkerton as Senior Vice President of Sales, North AmericaTodd Brinegar joins as CRO and Patrick Pinkerton as SVP of Sales, North AmericaRead more
Resources
Blog: Water and winter risk

Frozen pipe prevention for commercial buildings: a winter plan built on measurement

Published November 16, 20265 min read
Milvian AI teamFacilities and infrastructure intelligence
White pipework and junction boxes

Frozen pipe prevention in a commercial building means knowing, room by room, when an unheated space is getting cold enough to freeze water lines, and knowing within minutes when a line splits. That takes temperature sensors where pipes run exposed, alerts with a named owner, and line-level flow data that shows water moving in a building that should be still.

Why a mild forecast is not a reason to skip the plan

NOAA's winter outlook, published on 15 October 2026, names El Niño as the main driver for December to February and leans warmer than average across the northern US. An average says nothing about a single cold outbreak, and one night below freezing in a loading dock is enough to split a line.

Last January showed the cost. Coverage of Winter Storm Fern said the largest share of insured losses would fall on commercial property, from frozen pipes, roof damage and long power outages.

Where pipes freeze in a commercial building, and what to measure

LocationWhy it freezesWhat to measure
Loading docks and receiving baysDoors stay open for deliveries and wet sprinkler branches run along the exterior wall.Space temperature at the coldest wall, plus door open time where a contact sensor exists.
Ceiling voids under the roofPipes sit above the insulation line, where heat from the occupied floor never reaches.A reading inside the void, not the room below it.
Air handlers and rooftop unitsAn outdoor air damper stuck open pulls freezing air across water or hydronic coils.Mixed air reading and damper position, compared with conditions outside.
Closed floors and vacant buildingsHeating is set back or off, and nobody walks the space for days.Space temperature against the occupancy schedule, with a higher alert severity when the space is empty.
Stairwells, garages and riser closetsUnconditioned spaces that share a wall with outdoors.One sensor per riser closet that holds domestic or fire water lines.
Cooling towers and idle makeup linesWater left standing in winter freezes in basins and exposed piping.Basin and line temperature, and makeup flow while the tower should be idle.
Irrigation backflow preventersExposed valve bodies outdoors that were not drained in autumn.Flow on the irrigation line after the season ends, which should be zero.

Power loss is what turns cold into damage

IBHS guidance for businesses lists three ways plumbing and wet sprinkler systems freeze in extreme cold: power outages, building envelopes that are not sealed, and vacant buildings without proper heat. Two of those three are invisible to a monthly walk-through.

A freeze plan therefore has to keep reporting when the building loses power. Aqueduct's device Health tab shows each sensor's connection rate and battery voltage, so the team knows before a storm which readings it can trust and which sensor to replace.

How Aqueduct watches freeze risk and the thaw

Each at-risk space gets an automation rule: a temperature metric, a 'less than' condition and a severity that rises when the floor is unoccupied, using either occupancy sensors or the site schedule. The alert names the zone and the sensor, so the person on call goes to one riser closet instead of walking the building.

On the air side, the rooftop unit's digital twin shows outdoor air damper position next to outdoor air temperature, so a damper stuck open in a cold snap stands out. Where control is enabled, with owner approval, a rule can close that damper or switch on a unit heater through a relay, and the command history records that it ran.

Splits often show up at the thaw, not the freeze. Aqueduct compares each line with its own hourly profile, so water moving in an empty building at 3 a.m. raises a [burst alert](/features/burst-detection) rather than waiting for a ceiling stain.

Six steps before the first hard frost

  1. Walk the cold spacesList every dock, void, closet, garage and plant room where water or sprinkler pipe runs, with a photo of each.
  2. Place sensors where the pipe isMount temperature sensors at the coldest point near the pipe, not at the thermostat.
  3. Set thresholds and ownersGive each space an alert level and a named person, with escalation if nobody acknowledges.
  4. Test freeze stats and valvesIBHS advises testing low temperature sensing devices and valves before cold weather arrives, and having a licensed fire protection specialist maintain sprinkler systems.
  5. Record quiet-hour flowCapture what each line draws overnight and on weekends now, so a split during a holiday closure is obvious.
  6. Plan the holiday shutdownSet the occupancy schedule for late December closures so empty buildings get the stricter alert level.

Where this is going

Winter losses are lumpy. Triple-I, citing Aon, puts insured winter storm losses at about $15.5 billion in 2021, the year of the Texas freeze, against nearly $1.4 billion in 2025. A portfolio's exposure is set by the one bad week, not the average winter.

NOAA's Climate Prediction Center updates its seasonal outlook every month. Sites that have sensors in place by December can tighten thresholds when a cold outbreak shows up in the forecast instead of buying hardware during it.

Sources

SourceLink
NOAA, El Niño looms large over U.S. Winter Outlook (15 October 2026)noaa.gov
Insurance Journal, Winter Storm to Cause Billions of Dollars in Insured Losses: UBS (29 January 2026)insurancejournal.com
IBHS, Winter Ready Businessibhs.org
Triple-I, Facts and Statistics: Winter stormsiii.org
NOAA Climate Prediction Center, seasonal outlookscpc.ncep.noaa.gov
Questions

Questions about this topic

Yes. Each cold space gets its own low limit, and Aqueduct notifies the named owner once a reading falls under it, with higher severity on an empty floor. Loading docks, roof voids and riser closets are the usual places to start. Limits are set per zone in the digital twin view.

Yes, by flow. When a frozen section thaws and leaks, the line it sits on starts drawing water at hours when it is normally still. Aqueduct learns when each line normally sits idle and flags flow at those hours, so the leak is found the same night. See leak detection.

Aqueduct monitors the space around sprinkler piping, not the fire protection system itself. Temperature sensors near exposed sprinkler branches show when those areas run cold, and the alert goes to facilities. Inspection, testing and maintenance of the sprinkler system stay with a licensed fire protection contractor. More on water monitoring.

Battery sensors keep measuring through an outage, and readings reach Aqueduct as long as the gateway and its uplink stay powered. Devices with weak signal or low charge are flagged on their health record and swapped before the cold arrives. Planning backup power for gateways is part of the hardware setup.

See Aqueduct on your own facility.

Bring a site, a utility bill or a question. We will show you where the loss is.