Integration partners

Integration partner program for installers and integrators

The integration track is for system integrators, installers, MEP firms and commissioning agents who fit devices, connect building equipment and hand over a reporting site. Milvian AI does not install hardware.

Panel meters showing frequency, voltage and current
Digital multimeter
Device health
ERS-CO2 · Level 2, Zone 4
Connection reliability99.2%
Battery3.61 V
Last reading1 min ago
Demo data

You deploy and commission the site, and Aqueduct reports the results.

On site

The work an integration partner owns

  • Survey

    List what reports today, find blind spots and run the radio survey.

  • Install and connect

    Fit meters and sensors, and connect equipment over BACnet or Modbus.

  • Commission

    Place devices on floor plans, set zones and confirm device health.

Breakers and wiring in a panel

Who does what

TaskMilvian AIIntegration partner
Platform, data layer and twins.Builds and runs it.Uses it to deliver.
Survey and solution design.Platform guidance.Leads on site.
Hardware supply and installation.Does not install.Fits and commissions.
BMS and field connection.Provides integration points.Connects and tests.

Requirements

RequirementDetail
Field capability.Licensed and insured for metering, sensing or controls work in your regions.
Protocol experience.LoRaWAN, BACnet, Modbus or M-Bus.
Change control.Equipment commands run only where control is enabled, with owner approval.
Trusted at scale
Read the case studies
Deployed275+

sites in 21 countries run on Aqueduct.

Healthcare22 hospitals

and 9 clinics in one of India’s top hospital chains.

AirportsA top 25

US airport running water intelligence on Aqueduct.

Real estate20M+ sq ft

of commercial real estate under Aqueduct.

Manufacturing300 acres

FMCG manufacturing campus.

Food and dairyMajor dairy

operations run on Aqueduct.

Questions

Common questions

No. Milvian AI does not install hardware or take O&M contracts. Integration partners own survey, installation, BMS connection and commissioning, and use Aqueduct to deliver the result. See the partner program.

Yes. Engineers who specify metering and control points at design stage fit this track. Aqueduct publishes a copy-ready specification paragraph for new buildings, which MEP firms can drop into their drawings. See build it in.

Technicians commission each device in aQ Atria, which scans it, places it on the floor plan and checks it is reporting before the job closes. Device health then stays visible after handover. See aQ Atria.

See Aqueduct on your own facility.

Bring a site, a utility bill or a question. We will show you where the loss is.